First use grain tester Motomco Connect

For the first use it's required the bluetooth connect using the app, see the next steps how to do:

If you didn't download the app, see how on the FAQ here: 

Before start, be sure you already had the first full charge of the equipment then follow the steps:

1. Download the app (see how on the FAQ here)
2. You must turn on your equipment and connect with the smartphone
1. Assembly only the grain cell with the base.
2. As the page 7 on user guide press the power button and hold for 3 seconds.
3. It's recommended allow Wi-fi connection through Motomco Connect app
• OBS: some devices could ask the location permission instead, but the Motomco Connect app don't, be sure you allowed it
3. Find your Motomco Connect as the serial number and ask to connect
4. Select your new product
5. The dump cell may be in a tray and overfill with the product sample, than strike the sample with a line.
6. Assembly the dump cell into the grain cell
7. Dump the samples in the grain cell and remove the dump cell (follow the step according the bases screen.
8. The moisture tester will appear in the screen (if the smartphone is connect it'll also appear in your screen phone)

Since the second boot, the equipment has a shorter and simple routine. For the Motomco Connect follow the steps:

1. Turn on the base
• Only with the grain cell assembly
2. Make sure about the Bluetooth connection
3. Step 5 + 6 + 7 of the last instructions

The video below is a great example to how you may proceed.